Humoral immune response to SARS-CoV-2 in pregnant and nonpregnant women following infection.

BACKGROUND: Immune changes that occur during pregnancy may place pregnant women at an increased risk for severe disease following viral infections like SARS-CoV-2. Whether these immunologic changes modify the immune response to SARS-CoV-2 infection during pregnancy is not well understood. OBJECTIVE: This study aimed to compare the humoral immune response to SARS-CoV-2 infection in pregnant and nonpregnant women. The immune response following vaccination for SARS-CoV-2 was also explored. STUDY DESIGN: In this cohort study, 24 serum samples from 20 patients infected with SARS-CoV-2 during pregnancy were matched by number of days after a positive test with 46 samples from 40 nonpregnant women of reproductive age. Samples from 9 patients who were vaccinated during pregnancy were also examined. Immunoglobulin G and immunoglobulin M levels were measured. Trends in the log antibody levels over time and mean antibody levels were assessed using generalized estimating equations. RESULTS: The median number of days from first positive test to sampling was 6.5 in the pregnant group (range, 3-97) and 6.0 among nonpregnant participants (range, 2-97). No significant differences in demographic or sampling characteristics were noted between the groups. No differences in immunoglobulin G or immunoglobulin M levels over time or mean antibody levels were noted among pregnant and nonpregnant participants following SARS-CoV-2 infection for any of the SARS-CoV-2 antigen targets examined (spike, spike receptor-binding domain, spike N-terminal domain, and nucleocapsid). Participants who were vaccinated during pregnancy had higher immunoglobulin G levels than pregnant patients who tested positive for all SARS-CoV-2 targets except nucleocapsid antibodies (all P<.001) and had lower immunoglobulin M spike (P<.05) and receptor-binding domain (P<.01) antibody levels. CONCLUSION: This study suggests that the humoral response following SARS-CoV-2 infection does not seem to differ between pregnant women and their nonpregnant counterparts. These findings should reassure patients and healthcare providers that pregnant patients seem to mount a nondifferential immune response to SARS-CoV-2.

Humoral immune response to SARS-CoV-2 in pregnant and non-pregnant women following infection

Background Immune changes that occur during pregnancy may place pregnant women at an increased risk for severe disease following viral infections like SARS-CoV-2. Whether these immunological changes modify immune response to SARS-CoV-2 infection during pregnancy is not well understood. Objective The objective of the present study is to compare humoral immune response to SARS-CoV-2 infection in pregnant and non-pregnant women. Immune response following vaccination for SARS-CoV-2 was also explored. Study Design In the present cohort study, 24 serum samples from 20 patients infected with SARS-CoV-2 during pregnancy were matched on number of days post positive test to 46 samples from 40 non-pregnant women of reproductive age. Samples from nine patients vaccinated during pregnancy were also examined. Immunoglobulin G (IgG) and immunoglobulin M (IgM) antibody levels were measured. Trends in log antibody levels over time and mean antibody levels were assessed using generalized estimating equations. Results Median number of days from first positive test to sampling was 6.5 in the pregnant group (range 3-97) and 6.0 among non-pregnant participants (range 2-97). No significant differences in demographic or sampling characteristics were noted between groups. No differences in IgG or IgM levels over time or mean antibody levels were noted in pregnant and non-pregnant participants following SARS-CoV-2 infection for any of the SARS-CoV-2 antigens targets examined [Spike, Spike Receptor Binding Domain (RBD), Spike N-Terminal Domain (NTD), and Nucleocapsid]. Participants vaccinated during pregnancy had higher IgG levels than pregnant positive patients for all SARS-CoV-2 targets except Nucleocapsid (all p < 0.001), as well as lower IgM Spike (p < 0.05) and RBD (p < 0.01) antibody levels. Conclusions The present study suggests that humoral response following SARS-CoV-2 infection does not appear to differ in pregnant women compared to their non-pregnant counterparts. These findings should reassure patients and healthcare providers that pregnant patients appear to mount a non-differential immune response to SARS-CoV-2.

SARS-CoV-2 Distribution in Residential Housing Suggests Contact Deposition and Correlates with Rothia sp.

Monitoring severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) on surfaces is emerging as an important tool for identifying past exposure to individuals shedding viral RNA. Our past work demonstrated that SARS-CoV-2 reverse transcription-quantitative PCR (RT-qPCR) signals from surfaces can identify when infected individuals have touched surfaces and when they have been present in hospital rooms or schools. However, the sensitivity and specificity of surface sampling as a method for detecting the presence of a SARS-CoV-2 positive individual, as well as guidance about where to sample, has not been established. To address these questions and to test whether our past observations linking SARS-CoV-2 abundance to Rothia sp. in hospitals also hold in a residential setting, we performed a detailed spatial sampling of three isolation housing units, assessing each sample for SARS-CoV-2 abundance by RT-qPCR, linking the results to 16S rRNA gene amplicon sequences (to assess the bacterial community at each location), and to the Cq value of the contemporaneous clinical test. Our results showed that the highest SARS-CoV-2 load in this setting is on touched surfaces, such as light switches and faucets, but a detectable signal was present in many untouched surfaces (e.g., floors) that may be more relevant in settings, such as schools where mask-wearing is enforced. As in past studies, the bacterial community predicts which samples are positive for SARS-CoV-2, with Rothia sp. showing a positive association. IMPORTANCE Surface sampling for detecting SARS-CoV-2, the virus that causes coronavirus disease 2019 (COVID-19), is increasingly being used to locate infected individuals. We tested which indoor surfaces had high versus low viral loads by collecting 381 samples from three residential units where infected individuals resided, and interpreted the results in terms of whether SARS-CoV-2 was likely transmitted directly (e.g., touching a light switch) or indirectly (e.g., by droplets or aerosols settling). We found the highest loads where the subject touched the surface directly, although enough virus was detected on indirectly contacted surfaces to make such locations useful for sampling (e.g., in schools, where students did not touch the light switches and also wore masks such that they had no opportunity to touch their face and then the object). We also documented links between the bacteria present in a sample and the SARS-CoV-2 virus, consistent with earlier studies.

Analysis of SARS-CoV-2 RNA Persistence across Indoor Surface Materials Reveals Best Practices for Environmental Monitoring Programs.

Environmental monitoring in public spaces can be used to identify surfaces contaminated by persons with coronavirus disease 2019 (COVID-19) and inform appropriate infection mitigation responses. Research groups have reported detection of severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) on surfaces days or weeks after the virus has been deposited, making it difficult to estimate when an infected individual may have shed virus onto a SARS-CoV-2-positive surface, which in turn complicates the process of establishing effective quarantine measures. In this study, we determined that reverse transcription-quantitative PCR (RT-qPCR) detection of viral RNA from heat-inactivated particles experiences minimal decay over 7 days of monitoring on eight out of nine surfaces tested. The properties of the studied surfaces result in RT-qPCR signatures that can be segregated into two material categories, rough and smooth, where smooth surfaces have a lower limit of detection. RT-qPCR signal intensity (average quantification cycle [Cq]) can be correlated with surface viral load using only one linear regression model per material category. The same experiment was performed with untreated viral particles on one surface from each category, with essentially identical results. The stability of RT-qPCR viral signal demonstrates the need to clean monitored surfaces after sampling to establish temporal resolution. Additionally, these findings can be used to minimize the number of materials and time points tested and allow for the use of heat-inactivated viral particles when optimizing environmental monitoring methods. IMPORTANCE Environmental monitoring is an important tool for public health surveillance, particularly in settings with low rates of diagnostic testing. Time between sampling public environments, such as hospitals or schools, and notifying stakeholders of the results should be minimal, allowing decisions to be made toward containing outbreaks of coronavirus disease 2019 (COVID-19). The Safer At School Early Alert program (SASEA) (https://saseasystem.org/), a large-scale environmental monitoring effort in elementary school and child care settings, has processed >13,000 surface samples for SARS-CoV-2, detecting viral signals from 574 samples. However, consecutive detection events necessitated the present study to establish appropriate response practices around persistent viral signals on classroom surfaces. Other research groups and clinical labs developing environmental monitoring methods may need to establish their own correlation between RT-qPCR results and viral load, but this work provides evidence justifying simplified experimental designs, like reduced testing materials and the use of heat-inactivated viral particles.

Dataset on optimization and development of a point-of-care glucometer-based SARS-CoV-2 detection assay using aptamers.

We present supplementary data for the published article, "Hitting the diagnostic sweet spot: Point-of-care SARS-CoV-2 salivary antigen testing with an off-the-shelf glucometer" [1]. The assay described is designed to be performed at home or in a clinic without expensive instrumentation or professional training. SARS-CoV-2 is detected by an aptamer-based assay that targets the Nucleocapsid (N) or Spike (S) antigens. Binding of the N or S protein to their respective aptamer results in the competitive release of a complementary antisense-invertase enzyme complex. The released enzyme then catalyzes the conversion of sucrose to glucose that is measured by an off-the-shelf glucometer. The data presented here describe the optimization of the assay parameters and their contribution to developing this aptamer-based assay to detect SARS-CoV-2. The assay performance was checked in a standard buffer, contrived samples, and patient samples validated with well-established scientific methods. The resulting dataset can be used to further develop glucometer-based assays for diagnosing other communicable and non-communicable diseases.

Hitting the diagnostic sweet spot: Point-of-care SARS-CoV-2 salivary antigen testing with an off-the-shelf glucometer.

Significant barriers to the diagnosis of latent and acute SARS-CoV-2 infection continue to hamper population-based screening efforts required to contain the COVID-19 pandemic in the absence of widely available antiviral therapeutics or vaccines. We report an aptamer-based SARS-CoV-2 salivary antigen assay employing only low-cost reagents ($3.20/test) and an off-the-shelf glucometer. The test was engineered around a glucometer as it is quantitative, easy to use, and the most prevalent piece of diagnostic equipment globally, making the test highly scalable with an infrastructure that is already in place. Furthermore, many glucometers connect to smartphones, providing an opportunity to integrate with contact tracing apps, medical providers, and electronic health records. In clinical testing, the developed assay detected SARS-CoV-2 infection in patient saliva across a range of viral loads - as benchmarked by RT-qPCR - within 1 h, with 100% sensitivity (positive percent agreement) and distinguished infected specimens from off-target antigens in uninfected controls with 100% specificity (negative percent agreement). We propose that this approach provides an inexpensive, rapid, and accurate diagnostic for distributed screening of SARS-CoV-2 infection at scale.

Handwashing and Detergent Treatment Greatly Reduce SARS-CoV-2 Viral Load on Halloween Candy Handled by COVID-19 Patients.

Due to the COVID-19 pandemic and potential public health implications, we are publishing this peer-reviewed manuscript in its accepted form. The final, copyedited version of the paper will be available at a later date. Although SARS-CoV-2 is primarily transmitted by respiratory droplets and aerosols, transmission by fomites remains plausible. During Halloween, a major event for children in numerous countries, SARS-CoV-2 transmission risk via candy fomites worries many parents. To address this concern, we enrolled 10 recently diagnosed asymptomatic or mildly/moderately symptomatic COVID-19 patients to handle typical Halloween candy (pieces individually wrapped) under three conditions: normal handling with unwashed hands, deliberate coughing and extensive touching, and normal handling following handwashing. We then used a factorial design to subject the candies to two post-handling treatments: no washing (untreated) and household dishwashing detergent. We measured SARS-CoV-2 load by RT-qPCR and LAMP. From the candies not washed post-handling, we detected SARS-CoV-2 on 60% of candies that were deliberately coughed on, 60% of candies normally handled with unwashed hands, but only 10% of candies handled after hand washing. We found that treating candy with dishwashing detergent reduced SARS-CoV-2 load by 62.1% in comparison to untreated candy. Taken together, these results suggest that although the risk of transmission of SARS-CoV-2 by fomites is low even from known COVID-19 patients, viral RNA load can be reduced to near zero by the combination of handwashing by the infected patient and ≥1 minute detergent treatment after collection. We also found that the inexpensive and fast LAMP protocol was more than 80% concordant with RT-qPCR.IMPORTANCE The COVID-19 pandemic is leading to important tradeoffs between risk of SARS-CoV-2 transmission and mental health due to deprivation from normal activities, with these impacts being especially profound in children. Due to the ongoing pandemic, Halloween activities will be curtailed as a result of the concern that candy from strangers might act as fomites. Here we demonstrate that these risks can be mitigated by ensuring that prior to handling candy, the candy giver washes their hands, and by washing collected candy with household dishwashing detergent. Even in the most extreme case, with candy deliberately coughed on by known COVID-19 patients, viral load was reduced dramatically after washing with household detergent. We conclude that with reasonable precautions, even if followed only by either the candy giver or the candy recipient, the risk of viral transmission by this route is very low.